Close sidebar

FAA issues mandate for additional 737 MAX MCAS inspections

written by Isabella Richards | June 18, 2021

The US Federal Aviation Administration (FAA) has released a mandate ordering all Boeing 737 MAX jet operators to conduct additional inspections on its automated flight control system, MCAS.

In December 2020, Boeing issued a recommendation that all MAX jets were required to be re-inspected if they had reached 6,000 flight hours, however, the FAA have now made this an official mandatory safety directive.

Advertisement
Advertisement

Specifically, the directive, dated 16 June, states aircraft are required to be checked an additional three times to “verify that functions have not failed.”

These inspections will be on top of existing ones, to “ensure the continued functioning of certain systems throughout the life of the airplane”, said the FAA in the statement.

The requirements include checking the stabiliser trim system, cut off switches, and systems related to the aileron and elevator actuator availability.

Boeing said it “fully supports the FAA mandate … requiring functional checks at certain intervals to the digital flight control system, stabiliser trim, and the primary and secondary aisle stand stabiliser”.

This comes after two fatal crashes in 2018 with Lion Air, and early 2019 with Ethiopian Airlines that resulted in the death of 346 passengers and air staff. For 20 months, the planes were grounded until November 2020 when they were recertified.

PROMOTED CONTENT

Along with the directive, the FAA issued a Continued Airworthiness Notification to the International Community (CANIC), urging “other international regulators and to operators outside the United States”, to follow this same mandate.

The FAA said the new implementation of inspections will impact 72 aircraft from the United States and, if other regulators from other nations follow suit, an additional 389 aircraft worldwide.

The Maneuvering Characteristics Augmentation System (MCAS) was deemed the root of the fatal crashes. The system is designed to activate manual flight control law, enhancing the pitch stability of the aircraft.

During flight, the system is triggered by a sensor, however, in this instance, the single sensor malfunctioned, resulting in the two crashes.

Now after all this time, while the MAX has been recertified, these safety directives and mandates highlight that the potential of a control system failure combined with unusual flight maneuvers could result in complete loss of control of the aircraft, therefore they are of highest “importance”, according to the FAA.

There is no indication yet that other regulators will follow this directive.

FAA issues mandate for additional 737 MAX MCAS inspections Comment

  • Ronnie

    says:

    This mandate is prudent, given the MAX is allowed back in the air with the known issue that MCAS is reliant on only two sensors and that Boeing has to develop a third within a specified period. The implication being two is acceptable for a limited time but three is necessary long term. It is therefore reasonable that inspections of the two sensor regime be carried out periodically to ensure it is fully operational as far as can be assured. So we are waiting to see what Boeing’s third sensor solution is.

Leave a Comment to Ronnie Cancel

Your email address will not be published. Required fields are marked *

Each day, our subscribers are more informed with the right information.

SIGN UP to the Australian Aviation magazine for high-quality news and features for just $99.95 per year